Follow These 4 Simple Steps

Ensuring a Clean Surface

No matter how clean we keep our items surfaces get dirty.

To ensure best adhesion, it's essential to clean the surface thoroughly prior to any application.

Our Process

1. Wash and rinse the area with dish detergent and warm water.  Dry the surface with a clean , lint-free towel or cloth.

2.  Wipe down the area with rubbing alcohol; to avoid recontamination wipe surface in one direction.

Your surface is now ready for application.

4. Apply

For smaller decals you can apply directly, however for larger decal adhere one side to the surface.

We recommend Masking Tape

For Small Decals

 Peel off the white paper backing and apply the sticky part to the glass or surface.

Applying from one side to the other will 

reduce air bubbles. Rub or squeegee on with a plastic squeegee. ( I.D. Cards work too)

For Larger Decals

Remove only a portion of the paper backing

and apply the sticky part to the glass or surface.

Applying from one side to the other will 

reduce air bubbles. Rub or squeegee on with a plastic squeegee. ( I.D. Cards work too)

Repeat until the backing entirely removed

  Now, Just peel off the remaining plastic or paper application tape very slowly at

a sharp angle away from the decal. If the decal starts to come up as well rub it

again or squeegee more then try again patiently.

Air bubbles happen. They are a normal part of application of decal.

  Any larger bubbles may be popped with a pin and lightly rubbed,

but most will go away on their own. Wrinkles can usually be massaged away with a heat gun.